Cirro Buds Pro

Cirro Buds Pro

Articles - Category Page

(8)
H
Cirro Buds Pro Charging

Charging It is recommended that the earbuds and charging case be fully charged before first use. ​​ ​ To charge the earbuds, place them in the charging case and close the lid. If the charging case is not connected to a power source, the charging case status LED will show which earbuds are charging.

Knowledge Base Article

 • 

Cirro Buds Pro

H
Cirro Buds Pro Factory Reset

Factory Reset To perform the factory reset, Place the earbuds in the case and the lid open, and hold the case button for 10 seconds. The LED will flash purple 3 times to indicate that the product has been factory reset.

Knowledge Base Article

 • 

Cirro Buds Pro

H
Cirro Buds Pro Overview

A. Charging contacts B. Proximity sensor C. Microphone D. Touch Sensor E. Charging case F. Charging case button G. Charging case status LED H. USB-C port I. Ear tips (large,small) J. USB-C to USB-A cable

Knowledge Base Article

 • 

Cirro Buds Pro

H
Cirro Buds Pro Charging Case Button

Press the charging case button to check the charging case’s battery level, indicated by flashing the case’s status LED. ​

Knowledge Base Article

 • 

Cirro Buds Pro

H
Cirro Buds Pro Quick Start Guide

Cirro Buds Pro Quick Start Guide

Knowledge Base Article

 • 

Cirro Buds Pro

H
Cirro Buds Pro Pairing Instructions

Power on the earbuds. The earbuds will automatically attempt to reconnect to their last Bluetooth® enabled device(s). The earbuds will automatically enter pairing mode anytime they are not connected to a Bluetooth® device. To enter pairing mode while connected to a Bluetooth® device, use the device’

Knowledge Base Article

 • 

Cirro Buds Pro

H
Cirro Buds Pro Earbuds Controls

Earbuds Controls Left Earbud Right Earbud Audio and Noise Control Modes

Knowledge Base Article

 • 

Cirro Buds Pro

H
Cirro Buds Pro Powering on and off the Earbuds

Powering on and off the Earbuds ​​ ​ To power on the earbuds, open the charging case. The earbuds will power on and the charging case status LED will flash to indicate the battery level of the charging case. The earbuds can also be powered on outside of the case by holding the touch sensors for 3 se

Knowledge Base Article

 • 

Cirro Buds Pro